NetBSD/hp300 1.0

Charles Hannum was the maintainer of NetBSD/hp300 at the time of release 1.0, but Jason Thorpe built the release.

NOTE: The binary release of NetBSD/hp300 1.0 is built from 1.0 source with patches 01 and 02 applied. These patches fix bugs that were inhibiting the hp300 release.

Supported Hardware

NetBSD/hp300 1.0 will run on most HP 9000/300 series computers. It has been tested on machines with as little as 7.5M of RAM. A minimal installation, less X and source, will fit on a 120M disk.

Devices supported by NetBSD/hp300 1.0 include:

• CPUs:
  • 68020-based: 318, 319, 320, 330, and 350
  • 68030-based: 340, 345, 360, 370, 375, and 400
  • 68040-based: 380, 425 and 433
• Disks:
  • HP-IB/CS80: 7912, 7914, 7933, 7936, 7945, 7957, 7958, 7959, 2200, and 2203
  • SCSI-I, including magneto-optical and CD-ROM
• Tape drives:
  • Low-density CS80 cartridge: 7914, 7946, 9144
  • High-density CS80 cartridge: 9145
  • SCSI: HP DAT and Exabyte
• RS232 interfaces:
  • 98644 built-in single port (dca)
  • 98642 4-port (dcm)
  • 98638 8-port (dcm)
• Network interfaces:
  • 98643 built-in and add-on LAN cards
• Displays:
  • 98544, 98545, and 98547 color and monochrome Topcat
  • 98548, 98549, and 98550 color and monochrome Catseye
  • 98700 and 98710 Gatorbox
  • 98720 and 98721 Renaissance
  • 98730 and 98731 DaVinci
  • A1096A monochrome Hyperion
• Input devices:
  • General interface supporting all HIL devices: keyboard, 2 and 3 button mice, and ID module
• Miscellaneous:
  • Battery-backed real-time clock
  • 98625A and 98625B built-in HP-IB interface
  • 98658A built-in SCSI interface
  • Printers and plotters on RS232 and HP-IB
  • SCSI autochanger

If you're interested in installing NetBSD/hp300 1.0, you should look at the installation notes.

Go to an FTP site that carries NetBSD/hp300.

1.0 Formal Release page

Home Page